SKE Crystal Plus Charging Instructions

July 7, 2026

SKE Crystal Plus Charging Instructions

How to charge your Crystal Plus device and what the LED indicator colours mean.

Quick answer: The SKE Crystal Plus charges via USB-C. Connect the included USB-C cable to the port at the base of the device and plug into any USB power source. A full charge takes approximately 30 to 60 minutes. The LED on the device indicates charge status: flashing while charging, solid when fully charged.

The SKE Crystal Plus is a rechargeable prefilled pod system. Unlike single-use disposables, the battery unit is rechargeable, making it more cost-effective and less wasteful. Here is everything you need to know about charging it correctly.

Charging Steps

Step 1: Locate the USB-C port

The USB-C charging port is located at the base of the Crystal Plus device (the battery unit). Remove the pod if it is connected and set it aside safely. The port is a small oval slot: do not confuse it with the airflow vent.

Step 2: Connect the USB-C cable

Insert the USB-C connector into the port at the base of the device. The connection is reversible so there is no wrong way to insert it. Connect the other end to a USB wall adapter, laptop USB port, or power bank. Any USB power source with a standard output (5V / 1A) will work.

Step 3: Monitor the LED indicator

The LED indicator on the device shows charging status. During charging the LED typically flashes or glows. When charging is complete the LED either turns off or shows a solid light: refer to the LED guide below for your specific indicator behaviour.

Step 4: Disconnect when fully charged

A full charge typically takes 30 to 60 minutes depending on how depleted the battery was. Disconnect the cable once charging is complete. Avoid leaving the device plugged in overnight as a habit, though modern lithium-ion protection circuits prevent overcharging.

LED Indicator Guide

LED behaviour	Meaning	Action
Flashing white (when plugged in)	Charging in progress	Leave connected until complete
Solid white (when plugged in)	Fully charged	Safe to disconnect
Flashing white (when vaping)	Battery low: needs charging	Charge before next session
No light (when vaping)	Battery depleted or pod not seated correctly	Charge device; check pod is fully clicked in
10 flashes then cut out	Short circuit or device protection triggered	Remove pod, reinsert, try again; contact retailer if persists

Safety note: Only charge with the supplied USB-C cable or a certified replacement. Do not charge from a high-output fast charger: standard 5V/1A is appropriate. Do not charge unattended overnight or in hot environments. Keep out of reach of children while charging.

Crystal Plus vs Crystal Bar: Key Difference

The SKE Crystal Bar (600 puffs) is a single-use disposable: it cannot be recharged and is discarded when the liquid is finished. The SKE Crystal Plus is a rechargeable pod kit: the battery unit can be recharged hundreds of times and the prefilled pods are replaced as each is used. The Crystal Plus is more economical for regular use and produces significantly less plastic waste per vaping session.

Frequently Asked Questions

The Crystal Plus battery provides approximately 400 to 500 puffs per charge, depending on puff duration and frequency. For most users, this equates to one to two days of typical use per charge. A moderate user going through roughly one 2ml pod per day should find the battery outlasts the pod, meaning charging and pod replacement can be synced conveniently.

It is not recommended. Vaping while charging (pass-through charging) puts additional stress on the battery and generates heat. For the best battery longevity and safety, charge the device with the pod removed and allow it to complete the charge cycle before using it again.

First check the USB-C cable is fully seated in the port. Try a different cable and a different power source (wall adapter vs laptop vs power bank) to rule out a cable or charger fault. Check the port for any debris: a toothpick can gently clear lint. If the device has been completely depleted, it may take a few minutes before the LED activates. If none of this resolves it, contact Celtic Vapours for warranty assistance.

Pod replacement is needed when the e-liquid has run out: indicated by a burnt or dry taste, significantly reduced vapour production, or the pod feeling light when shaken. A pod typically lasts around 600 puffs. The battery may still have charge when a pod runs out: simply swap in a new pod and continue. The battery and pod have independent lifespans.

Browse Crystal Plus pods and kits at Celtic Vapours

Browse Crystal Pods Shop E-Liquids Nic Salts