Quick Fixes When Your SKE Crystal 600 Pro Stops Firing

July 7, 2026

Quick Fixes When Your SKE Crystal 600 Pro Stops Firing

Diagnose and fix the most common reasons a Crystal 600 Pro stops producing vapour.

Quick answer: The three most common reasons a Crystal 600 Pro stops firing are: the device is empty (burnt taste beforehand), the battery is dead (no LED and no vapour), or the mouthpiece seal was never removed (visible as a silicone cap on the mouthpiece). Work through these checks in order before assuming a fault.

The Crystal 600 Pro is a simple device with few components that can fail. Most non-working situations have an obvious cause and a quick resolution.

Diagnostic Table

Symptom	Most likely cause	Fix
No vapour, LED flashes briefly	Battery depleted	Device is finished. Dispose of correctly and replace.
No vapour, no LED at all	Battery dead or mouthpiece seal blocking airflow	Check mouthpiece for seal; if clear, battery is dead. Dispose and replace.
Vapour but strong burnt taste	Device empty; coil dry	Device is finished. Replace immediately.
Vapour but very thin, weak flavour	Device nearly empty; battery low	Last 50 to 100 puffs remaining. Replace soon.
Gurgling with liquid in mouth	Coil flooded	Blow gently through the airflow vent (not mouthpiece). Wait 60 seconds before next draw.
Intermittent firing (sometimes works, sometimes not)	Airflow vent partially blocked; condensation on sensor	Clear airflow vent; wipe mouthpiece and exterior; try again
Draws fine but no nicotine effect	Counterfeit product with low or no nicotine	Check authenticity code. Buy only from authorised retailers.

Root causes of Crystal 600 Pro non-firing issues (approximate frequency)

Longer bar = more commonly the cause. Empty device and dead battery account for most cases.

Device empty (burnt taste beforehand)

~48%

Battery dead (end of device life)

~28%

Mouthpiece seal not removed

~13%

Flooded coil

~7%

Hardware fault

~4%

When to Contact Celtic Vapours

If the device stops firing very early in its life (within the first 50 puffs) with no signs of being empty or battery-depleted, and the mouthpiece seal has been removed, it may have a manufacturing fault. Contact Celtic Vapours with proof of purchase. Genuine manufacturing defects are rare but covered by warranty support when purchased from an authorised retailer.

Frequently Asked Questions

At 150 puffs per day, a Crystal 600 Pro lasts approximately 4 days. If it stopped after one day, the most likely explanation is heavier use than expected (long draws, chain vaping, sharing the device). Check whether there is a burnt taste, which confirms the device is empty rather than broken. If the taste was fine right up until it stopped with no battery LED response, the battery may have been defective.

No. The Crystal 600 Pro is a single-use device with a non-rechargeable battery. The battery is calibrated to last approximately the same duration as the 2ml liquid supply under normal use. If the battery fails before the liquid is exhausted, the remaining liquid cannot be accessed. This is one of the practical limitations of single-use formats compared to rechargeable pod kits.

A blinking LED without vapour on a single-use device typically means the battery is critically low and cannot deliver enough power to fire the coil. This is an end-of-life signal. The device has effectively run out of battery. Dispose of it at a WEEE recycling point and replace with a new device.

There are no user-serviceable components in the Crystal 600 Pro. The sealed construction means there is nothing to repair, adjust or replace. If the issue is a flooded coil, blowing through the airflow vent is the only practical user intervention. All other non-working states (empty device, dead battery, manufacturing fault) require device replacement rather than repair.

Browse Crystal pod kits at Celtic Vapours

Browse Pod Kits Shop E-Liquids Nic Salts